21
TST-Doc-507FT-RV WSD-C Manual-(D)
In every instance, the tire Pressure and Temperature numbers will also flash
when the tire with the problem blinks.
● How do I remove my trailer from the display screen when I am not using
it?
To electronically disconnect the trailer tire icons from the screen:
1) Momentarily press the "GO" and (-) buttons at the same time.
2) The trailer section on the display will disappear.
3) To electronically reconnect the trailer section, momentarily press the "GO"
and (-) buttons again.
● How do I remove my towing vehicle from the display screen when it is
parked?
To electronically disconnect the towing vehicle tire icons from the screen:
1) Momentarily press the "GO" and (+) buttons at the same time.
2) The towing vehicle section on the display will disappear.
● Why does my display sometimes alarm while I am sitting still in the
evening?
As night approaches and outdoor temperatures decrease, your tire pressures
may drop below the parameters you have set, thus causing an out of spec
alarm. When temperatures drop, turn your display off overnight. As the air
temperature rises the next day or as you start driving, the tires will also heat up
and come back into your parameters. You can also add air to your tires to bring
them back into the parameters you set up.
● Why can't I set a lower pressure than 100 PSI for the High
Pressure alarm?
The high-pressure alarm cannot go lower than the low-pressure alarm setting.
If your tire pressure settings are below 100 PSI, you must first set the low-
pressure alarm settings and then set the axles'high-pressure settings. When
done, be sure to press and release the "SET" button to save all the parameter
settings.
● What conditions cause the display to alarm?
The display will alarm for the following reasons:
1) A rapid leak ("FAST LEAK" at bottom of screen).
2) A low sensor battery (upper left battery icon flashes).
3) An overheating tire, increasing the temperature ("HIGH TEMP" at bottom of
screen).
4) A high or low-pressure reading (be sure your parameters are setcorrectly).
To Next Page
Loading...