22
TST-Doc-507FT-RV WSD-C Manual-(D)
● How do I remove an unwanted tire icon from the display?
1) To delete a single sensor code:
2) Press the "SET" button until it beeps (approx. 3 seconds). Push the (+) button
and scroll through the parameters until "LEARN ID" appears. Press and
release the "SET" button. Use the (+) or (-) buttons to scroll to the tire you
wish to remove. Press the "SET"button to select that tire. It will start flashing.
Press the "BACK" button until you hear 3 beeps.The code will change to "FFF
FFF" which will be flashing. Press "SET"once. The flashing will stop and the ID
code will be deleted. To cancel the function, press the "BACK" button. This
will keep the original code.
Note: To delete all the sensor codes when in the "LEARN ID" mode, select any tire
icon and press the "SET" button so the 6 digit code blinks. Press and hold
the "BACK" button. You will hear 3 quick beeps, a pause and then 6 beeps.
"DEL ALL" will appear on the screen. Press "SET" once. "FFF FFF" will appear
on the screen. All the sensor codes and tire icons are now deleted. This does
not affect the parameters set in the display. Press the "BACK" button to go
to the Main Screen.
3) To electronically reconnect the towing vehicle section, momentarily press the
"GO" and (+) buttons again.
To Next Page
Loading...