REPEATER
Repeater
TST-Doc-507FT-RV WSD-C Manual-(D)
23
The repeater is used to strengthen/amplify the sensor signal forward to the display.
A repeater is packaged with this system.
The repeater comes with two wires, one red (+) and one black (-). Simply tie the red
wire to a positive source and black wire to a ground or negative source. The
repeater is weather resistant. There is no set-up needed for the repeater.
Motorhome: We recommend installing the repeater in one of the rear basement
compartments where there is a 12v power source. Mount the unit inside the bay
but against the outer wall. Do not put the repeater in the engine compartment
because of excessive heat. Do not put the repeater in the rear closet because the
metal in the mirror will block the repeaters RF signal.
5th Wheel: We recommend installing the repeater in or near the battery
compartment under the front overhang. Mount it with Velcro or two-sided tape to
the inner, exterior 507FT-RV WSD Manual ChangesRV wall. An alternate mounting
place is on the top of the pin-box. Use industrial two-sided tape and mount the
repeater on the upper slope of the pin-box. Run the positive lead to the break-
away switch (which has 12v power while driving). Ground the negative lead to
complete the circuit.
Travel Trailer: We recommend installing the repeater in the battery box on the
front of the trailer. If the battery box is metal, hook the lines to the battery, then run
the lines outside of the box and mount on the side of the battery box or the front
tongue of the travel trailer.
Be sure in all cases the red indicator light is glowing and every 2-3 minutes (with
the display on) the red light blinks. DO NOT push the button the red light is
mounted in!
If the light is not on, check your connections, source power or the in-line fuse on
the positive lead of the repeater for issues.
To Next Page
Loading...