TST TM-507 - Sensor Installation - Cap Sensor

SENSOR INSTALLATION - Cap Sensor
TST-Doc-507FT-RV WSD-C Manual-(D)
1. Screw the hex nut onto the valve stem threads until it bottoms out.
2. Screw the correctly marked sensor onto the valve stem for that tire position.
Tighten the sensor until the air stops leaking and the sensor bottoms-out on
the valve stem.Then give it a quarter turn more to seat it.Do Not Over Tighten!
3. Use your fingers to screw the hex nut up to the bottom of the sensor. Using the
provided wrench, tighten the hex nut against the bottom of the sensor. This will
prevent the sensor from being removed. Keep the wrench in a safe place for
future use.
4. To inflate or deflate the tire, you must remove the cap sensor.
4
Sensor valve cap
Install the sensor valve cap
onto the sensor.
4
Tighten the anti-theft hex nut
counterclockwise until the nut
is tightened against the
sensor.
3
3
Tighten the hex nut
Specified
wrench
Install the anti-theft hex
nut onto the tire valve.
1
Install the sensor onto the
tire valve clockwise.
2
Anti-theft hex nut
Tire valve
1
2
Tighten the anti-theft hex nut
counterclockwise until the nut
is tightened against the sensor.
3
Specified
wrench
Tighten the hex nut
3
3 4