SENSOR INSTALLATION - Flow-through Sensor
1. Screw the hex nut onto the valve stem threads until it bottoms out.
2. Screw the correctly marked sensor onto the valve stem for that tire position.
Tighten the sensor until the air stops leaking and the sensor bottoms-out on
the valve stem. Then give it a quarter turn more to seat it.Do Not Over Tighten!
3. Use your fingers to screw the hex nut up to the bottom of the sensor. Using the
provided wrench, tighten the hex nut against the bottom of the sensor. This will
prevent the sensor from being removed. Keep the wrench in a safe place for
future use.
TST-Doc-507FT-RV WSD-C Manual-(D)
1. Push the "SET" button until it beeps. You are now in the programming mode.
The "HI PRESSURE SET" parameter will blink at the bottom of the screen. Push
the (+) button and scroll through the parameters until "SET ID" appears.
4. You can now inflate or deflate the tire through the 507FT sensor without
removing it.
2. Quickly press and release the "SET" button. The first tire on the display will blink.
If you want to program a different tire, press the (+) button to move to the
correct tire. Push the "SET" button again and the first digit of "FFF FFF" will flash.
Press the (+) buttonto select the correct number or letter. Press "GO" to move
to the next position. Press the (+) button to change to the correct number or
letter. Continue this procedure until all six digits are changed.
3. Press "SET" once to save the new codes. You will hear a beep and the code will
stop flashing. Press the (+) button to move to the next tire position, if desired.
4. To stop the coding for any position, press "BACK" once. "FFF FFF" will reappear.
No settings will be saved.
5. Press "BACK" twice to return to the Main Screen.
1
Tire valve
Anti-theft hex nut
Sensor
2
Install the sensor onto the
tire valve clockwise.
Install the anti-theft hex nut
onto the tire valve.
1
1
2
To Next Page
Loading...