TST TM-510 User Manual

DISPLAY INSTALLATION
• There are two ways to mount the display to your dash.
• The vent clip can be aached to the display and then
clipped inside one of the vehicle A/C vents.
• Oponally, the provided velcro pads can be used to
secure the display to the top of the dash.
• Plug the power cord into the vehicle’s power port and
then into the side of the monitor to charge the internal
lithium baery. Charge the display for four (4) hours the
rst me.
• An oponal hardwire cord is provided if you choose to
wire the display into your vehicle’s ignion switch. In this
case, the monitor will automacally come on when the
ignion is on.
PARAMETER SETTINGS (Seng the sensor alarms)
NOTE: The factory default sengs are:
Pressure Unit: PSI Temperature units: °C
High Pressure: 175 lbs. High Temperature: 70°C (158° F)
Low Pressure: 100 Lbs.
TST-Doc-510 Manual-(A)
Truck System Technologies - 4250 Keith Bridge Road, Suite 200, Cumming, GA 30041
info@tsttruck.com
10

TST TM-510 Specifications

General

Brand	TST
Model	TM-510
Category	Measuring Instruments
Language	English