TST TM-510 - SENSOR INSTALLATION

• Using the (+) or (-) buon, navigate to the re on the
monitor you are standing at.
• Again, nish screwing that sensor down to seat it. That
code now will appear on the monitor.
• Connue this procedure unl you have coded all the
sensor posions.
• Finally, press the “SET” buon unl it beeps to save all
the sensor codes in the monitor.
SENSOR INSTALLATION
• Be sure to write down your sensor code in this manual in
the correct re posion for future reference.
• Using one of the tools included with your kit, slip the
sensor into the tool.
• Screw the correct sensor onto the valve stem for that re
posion. Tighten the sensor unl the air stops leaking
and the sensor booms-out on the valve stem. Then give
it a slight twist to seat it. Do Not Overghten!
• We suggest adding dielectric grease to the sensor threads
to prevent the threads from seizing to the valve stem
over me.
TST-Doc-510 Manual-(A)
Truck System Technologies - 4250 Keith Bridge Road, Suite 200, Cumming, GA 30041
info@tsttruck.com
9