TST TM-510 - Other Functions

NOTE: This low baery alert will display for only a short me unl
the baery is exhausted. If you do not have the monitor on oen,
the indicator signal will be sent but not displayed on the screen
since it was o. If your sensor is not reporng to the display, you
may have to replace the sensor. Call TST for Tech Support.
OTHER FUNCTIONS
Normal Display Scrolling
The display will automacally scroll/cycle through the coded
res one by one. Each re will be displayed for approximately
5-6 seconds. You can manually cycle through the coded res
by pushing the (+) or (-) buons on the display. The display will
show the re you choose for approximately 10 seconds before
connuing to cycle.
Backlighng and Moon Detecon
The display is equipped with a light sensor and a moon sensor.
The backlight will turn on when the vehicle is in moon and there
is lile ambient light. If the vehicle has stopped for a while and
the display is on the internal baery, the display will “go to sleep”
unl the vehicle resumes moon. To shut the light sensor o,
press the “+” buon for approximately 4 seconds.
Disconnecng and Reconnecng a Towed Vehicle
When a towed vehicle is displayed on the screen and you
want to temporarily remove it (example: leaving a trailer at a
campground), press and hold the “MODE” and (-) buons unl
Low Sensor Battery Alert
TST-Doc-510 Manual-(A)
Truck System Technologies - 4250 Keith Bridge Road, Suite 200, Cumming, GA 30041
info@tsttruck.com
15