TST TM-510 - AUTOMATIC CODE LEARNING (Option #2)

• To remove the re icon from the screen, the four-digit
code has to display all F’s. With the rst digit ashing, set
it to “F” using the (+) or (-) buons.
• Press “MODE” to move to the next digit. Set that to “F.”
• Connue to set all the digits to “F.” When done and with
“FFFF” showing on the screen, press and hold the set
buon unl it beeps. This will save the code you entered
and exit the programming mode.
Note: When in the coding mode, the display will me-out within
approximately one (1) minute if no buons are pushed. At that
point, you will have to again hold the “SET” buon down and
start the coding process again.
AUTOMATIC CODE LEARNING (Opon #2)
• Be sure your display is ON and it is showing the main
screen.
• Be sure your sensors are numbered. Screw the sensors
partly onto each valve stem in the order you numbered
them. Do NOT screw them down far enough to hear air
hissing out.
• Hold the “SET” buon down unl you hear a second
beep and then release.
• Navigate to the re icon you want to code that sensor to
on the display.
• Stand by that re and screw the sensor all the way down
to seat it.
• The sensor will immediately transmit its four-digit code
to the display and it will be displayed.
• Physically move to the next re posion you want to
code.
TST-Doc-510 Manual-(A)
Truck System Technologies - 4250 Keith Bridge Road, Suite 200, Cumming, GA 30041
info@tsttruck.com
8