• When done programming the Parameters into the
display, remember to quickly push and release the “SET”
buon to save the Parameters.
• To save the sensor codes when done coding all the
sensors, press and hold the “SET” buon. The display will
beep and the codes are saved. You will then be returned
to the Main Screen.
• If your re pressure is under 100 lbs., you will have to
program the Low-Pressure alarm rst and then come
back around and program the High-Pressure alarm. The
high pressure cannot go lower than the low-pressure
seng, which defaults to 100 lbs.
• When the display is on and reading, you can press the (+)
or (-) buons to quickly scroll through the res on your
display. The automac scrolling funcon will resume
aer 10 seconds when no buons are pushed.
• If your sensor is not transming data to the display, try
removing the sensor from the re stem and, aer waing
5 seconds, screw the sensor back onto that stem. This
resets the sensor electronics.
• If your display is plugged into a constant 12v power
source, the power switch (“-“ buon) will not funcon.
To turn the monitor o, unplug the power supply and
then push the (-) buon to shut o the display.
• To extend the life of the sensor baery, remove the
sensor from the valve stem. The internal pressure switch
will shut the baery o. Note that, even though the
baery is o, it will sll degrade with me.
To Next Page
