TST TM-510 - Page 20

• How do I remove my trailer from the display screen
when I am not using it?
To electronically disconnect the trailer re icons from the
screen:
1. Press and hold the “MODE” and (-) buons.
2. When the trailer secon on the display disappears,
release the buons.
3. To electronically reconnect the trailer secon, again,
press and hold the same “MODE” and (-) buons.
4. When the trailer secon on the display reappears,
release the buons
• How do I remove an unwanted re icon from the dis-
play?
1. Hold down the “SET” buon unl it beeps and then
release it.
2. Navigate to the re you want to remove from the
screen by quickly pressing the “SET“ buon to move
through the re icons.
3. When at the correct re, use the (+) or (-) buons to
adjust the rst digit to an “F”.
4. Quickly push and release the “MODE” buon to
move to the next digit. Set that to “F”.
5. Connue unl all digits are set to “F”.
6. When “FFFF” is showing, press and hold the “SET”
buon unl it beeps to save the code.
7. You will be back to the Main Screen and the re icon
will be gone.
TST-Doc-510 Manual-(A)
Truck System Technologies - 4250 Keith Bridge Road, Suite 200, Cumming, GA 30041
info@tsttruck.com
20