Logic Output (PL330 QMT)
Output Voltage Range: 4 to 6 Volts
Output Current: 0.1 to 7 Amps.
Output Switch: Electronic
Output Terminals: 4mm terminals on 19mm (.75") spacing.
Over-Voltage Protection: Above 7 Volts
Output Protection: Clamped by the over-voltage protection circuit for forward voltages
over 7 Volts and up to 1 Amp forward current. Diode clamped for
reverse voltages and up to 3 Amps reverse current.
Load Regulation: <0.01% of maximum output for 90% load change
Line Regulation: <0.01% of maximum output for 10% line voltage change
Remote Sense: Eliminates up to 0.5V drop per lead
Ripple and Noise: Typically <1mV rms
Transient Response: <20usec to within 50mV of setting for 90% load change
Temperature Coefficient: Typically <100ppm/°C
Meter Type: 3.75 digit (4095 count) with 12.5mm (0.5") LEDs. Reading rate 4 per
second.
Meter Resolution:
Voltage: 10mV
Current: 10mA
Meter Accuracy: 0.5% of reading + 1 digit
Logic Output (PL320 QMT)
Output Voltage Range: 4 to 6 Volts
Output Current: 0.1 to 4 Amps.
Output Switch: Electronic
Output Terminals: 4mm terminals on 19mm (.75") spacing.
Over-Voltage Protection: Above 7 Volts
Output Protection: Clamped by the over-voltage protection circuit for forward voltages
over 7 Volts and up to 1 Amp forward current. Diode clamped for
reverse voltages and up to 3 Amps reverse current.
Load Regulation: <0.01% of maximum output for 90% load change
Line Regulation: <0.01% of maximum output for 10% line voltage change
Remote Sense: Eliminates up to 0.5V drop per lead
Ripple and Noise: Typically <1mV rms
Transient Response: <20usec to within 50mV of setting for 90% load change
Temperature Coefficient: Typically <100ppm/°C
Voltage Setting Accuracy: Better than ± 0.1V
4
To Next Page
Loading...
