7. Menu Setting Mode
On( ) / Off( )
High( ) / Low( )
Off( ) and 1~99 Sec.
Continue( ) and 1-99 Sec.
Off( ) and 1~99 Sec.
Beep Tone
Backlight Dimmer
Noise Blanker
Scan Delay Timer
(after Receiving signal)
Scan Receive Timer
Time-out Timer
On( ) / Off( )
Display SettingsFunctions
Pressing the Emergency/Backlighting button, turn on the transceiver. The
transceiver goes to the Menu Setting Mode, which has the following
menu features. This menu setting mode allows you to program user
preferences, activate features and use advanced functions.
10
TCB-560
ENGLISH
Note :
1.
2.
3.
Use the AM/FM button to selecte the main menu features such as
Beep Tone, Time-out Timer, Scan Receive Timer, Scan Delay Timer
and Backlight Dimmer.
Use the up/down buttons to select or change any value that you
like to have while the values are blinking.
Press the PTT button of the Microphone to complete the selections
and changes and return to the stand-by mode. Or the selections and
changes will be automatically confirmed after 5 seconds of the
selections and changes.
Noise Blanker : The NB circuit helps to eliminate most electrical impulse
interference caused by engine ignition system etc. This allows clearer
reception of weak signals even under noisy electrical conditions.
To Next Page
Loading...
