TTI TX-446 - Channel Scanning Operation; Talkback Communication; Deleting Nuisance Channels

english
11
english
Scan
This feature allows you to monitor all the channels automati-
cally for valid signals. Your dealer can program more than
16 channels on the scan list.
Scan operation
By pressing a side button in which the
scan
function is
programmed, you can operate the scan function.
1. Press the
scan button
to begin scanning.
scan button to begin scanning.scan button
2. Press the
scan button
one more time to stop scanning.
scan button one more time to stop scanning.scan button
Note :
The
LED
flashes green color while scanning.
Talkback
With the talkback function being activated, if your radio has
scanned a channel on which there is a party with whom you
want to talk, you can directly communicate with the party by
pressing and holding down the PTT Button.
Deleting a Nuisance Channel
When the radio has scanned a channel which you don‘t want
to hear, you can temporarily remove the channel from the
scan list by using the
nuisance channel delete
feature.
If the radio is locked onto a unwanted channel, press the
nuisance delete
button until you hear beep two times.
nuisance delete button until you hear beep two times.nuisance delete
Note :
If the priority function is programmed by your dealer, you
cannot remove the priority channel from the scan list. The last
channel also cannot be deleted from the scan list.
Note :
To bring a deleted nuisance channel back into the scan list, you
must reset the radio.