Tunturi Aircycle E603 - Page 13

SETTING THE ELECTRONICS
MODULE FOR YOUR
PERSONAL GOALS:
To preset your exercise time:
1. Make sure STOP appears In the
display. Then press MODE until
the arrow in the display points to
TIME. If the word SCAN appears
in the display, press MODE
again.
2. Press SET ▲ to advance the
preset time one minute. Hold
down SET ▲ to advance quickly
to the desired time (from 0 to 99
minutes). A bell symbol appears
in the display to indicate that
the count-down timer is set.
3. If you advance the preset timer
farther than desired, press the
SET ▼ key to decrease the
preset time by 1 minute.
4. P ress START/STOP. The elec¬
tronics module begins to count
down in seconds. The time re¬
maining is displayed. A tone
sounds when the present time
reaches zero (0.00).
If you do not preset your exer¬
cise time, the elapsed time is
displayed and the bell symbol
does not appear.
To preset your exercise distance:
1. M ake sure STOP appears in the
display. Then press MODE until
the arrow in the display points to
the distance, if the word SCAN
appears in the display, press
MODE again.
2. Press SET ▲ to advance the
preset distance by 1/10 of a mile.
Hold down SET ▲ to advance
quickly to the desired distance
(.10 to 99.00). A (( ■ )) symbol ap¬
pears in the display to indicate
that the count-down distance is
set.
3. If you advance the preset
distance farther than desired,
press the SET ▼ key to decrease
the preset distance by 1/10 of a
mile.
4. Press START/STOP. The elec¬
tronics module begins to count
down in 1/10 mile increments.
The distance remaining is
displayed. A tone sounds when
the preset distance reaches zero
( 0 . 00 ).
If you do not preset your exer¬
cise distance, the elapsed dis¬
tance is displayed and the (( ■ ))
symbol does not appear.
13