Need help?Do you have a question about the Turbo E2T Series and is the answer not in the manual?
General| Brand | Turbo |
|---|---|
| Model | E2T Series |
| Category | Controller |
| Language | English |
Lists the key features and capabilities of the economiser device.
Sets the operating mode: Manual, Automatic, Automatic with forced cycle, or Proportional.
Defines the dP level that triggers the start of a cleaning cycle.
Defines the dP level that suspends the cleaning cycle.
Sets the dP level that triggers a maximum pressure alarm.
Sets the minimum dP threshold for the alarm (broken sleeve/cartridge).
Alarm triggered when maximum dP is exceeded for an extended period.
Explains how the device operates autonomously for pneumatic cleaning based on dP.
Details how the economiser functions as a programmable cycle sequencer in manual mode.
Describes forced cleaning cycles initiated independently of dP thresholds.
Troubleshooting steps for when the display does not light up.
Resolving issues where outputs are not activated.
Diagnosing and correcting incorrect differential pressure readings.
Troubleshooting why cleaning cycles are not carried out or start incorrectly.
Addressing issues with alarm messages and signaling devices.
Investigating causes for the economiser occasionally resetting.
Troubleshooting why the 0.0 kPa value does not appear when the fan is off.
To Next Page
