Turbo Eco-Net 128 - Connection Layout to the ERCP Pilot Enclosure Boxes

U s e r I n s t r u c t i o n s
Eco-Net 128 Control Unit
10
TURBO s.r.l. Dust Filter Components
Via Po 33/35 20811 Cesano Maderno (MB) Italy Tel ++39 0362 574024 Fax ++39 0362 574092
InMn 26 UCESTD
Rev.1.02 it
Connection layout to the ERCP pilot enclosure boxes
Connect the 3-wire cable coming from the IN connector of the first pilot enclosure box for pneumatic
drive (ERCP) present in the system, to the P11 connector of the Econet control unit, as shown in the
following layout:
Key:
1
Remote pneumatic valve
2
Connection pipe between remote pilot and the valve
3
Enclosure with built-in pilots for driving valves
4
Connection cabling between the ERCP pilot enclosure boxes
5
Connection cabling between the control unit and the pilots
enclosure box
Several pilots enclosure boxes are present in the system; connect them in
sequence in a way that the OUT connector of an ERCP pilots enclosure
box is connected to the IN connector of the next ERCP pilots enclosure
box.
Use a connection cable made with a DIN 43650 connector, to fix onto a
cylindrical base, making sure that the relative IP sealing gaskets are
mounted.
Complete installation by hermetically closing the OUT connector of the
last ERCP pilots enclosure box present in the system.