U s e r I n s t r u c t i o n s
TURBO s.r.l. Dust Filter Components
Via Po 33/35 20811 Cesano Maderno (MB) Italy Tel ++39 0362 574024 Fax ++39 0362 574092
InMn 26 UCESTD
Rev.1.02 it
Warning Symbols Used in the Manual
The indications regarding safety are highlighted using the following symbols:
Dispose of according to the WEEE Waste Electrical
and Electronic Equipment Directive
Installation regulations and warnings
Protect the equipment from direct exposure to sunlight.
Position the equipment away from sources of heat or electromagnetic fields generates by
equipment being used.
Fix the equipment to the wall at a height of at least 60 cm from the ground; it must be clearly
visible and easy to reach.
Connect the equipment to supply lines different to those used for motor drives or other large
power devices that could generate network disturbances or instability.
The appliance electric power supply must be protected by a 230Vac~ 30 mA differential circuit
breaker and a 230Vac~ 10 A bi-polar magnet circuit breaker, positioned in a place that is easy to
reach.
Before intervening on the appliance to perform any operation, deactivate the magnet circuit
breaker.
For electrical operations, always remove the voltage and wait 30 seconds for the internal capacitors
to discharge before opening the container.
When finished, close the device before turning on power.
Make sure you are in a safe atmosphere before using the equipment for any type of operation.
Use flame-proof cables with minimum section of 0.75mm² certified and compliant with regulations
to connect the power supply voltage.
Use flame retardant cables with a minimum section of 0.5 mm² for all input control signals and
valve actuators.
Use flame retardant cables with a minimum section of 0.75 mm² for signal relay contacts.
The protective earth cable must be yellow/green.
The protective earth cable must be connected first.
The yellow/green cable must only be used for earthing.
Continues....
To Next Page
Loading...