Turbo Eco-Net 128 - Counters; Secondary Menu

U s e r I n s t r u c t i o n s
Eco-Net 128 Control Unit
InMn 26 UCESTD
it Rev.1.02
TURBO s.r.l. Dust Filter Components
Via Po 33/35 20811 Cesano Maderno (MB) Italy Tel ++39 0362 574024 Fax ++39 0362 574092
15
Counters
Description
Unit
of
measurement
Factory settings
Range
5.1
Hours Power
The control unit switch-on hour meter is
displayed.
HH
0
0
9999999
5.2
Pulse count
The Counter of the valve activation
connected to the Bus is displayed
0
0
9999999
5.3
Fan Hours
The filter fan switch-on hour meter is
displayed. The counter is subject to the
activation of the Hourmeter Fan function.
HH
0
0
9999999
Secondary Menu
The secondary menu is used to configure the status of the relays, the buzzer and the back-lighting of
the display, and is accessible as follows:
1) Press the “MENU” button from the main screen;
2) Holding down the second button from the left, press the "OK" button
The parameters are organised as follows:
Description
Parameter
Unit
of
measurement
Factory settings
Range
6.1
Display back-lighting time
The duration of the LCD back-lighting
is set in seconds. If set at “0” it is
always on.
Back-light T
Sec.
0
0
50000
6.2
Status of Relay 1 contact
The rest status of Relay 1 alarm
contact is set
RL1:No/Nc:
Close
Open
Close
6.3
Method of activation of Relay 1
The activation mode of Relay 1 during
the associated alarm is set
RL1: Mode:
Time
Pulse
Latch
6.4
Duration of activation of Relay 1
The duration of activation of Relay 1
during the associated alarm is set, if
the previous parameter is configured
"Time"
RL1: Time:
Sec.
00010
0
50000
6.5
Status of Relay 2 contact
The rest status of Relay 2 alarm
contact is set
RL2:No/Nc:
Close
Open
Close