Turnigy MEGA 1000W - Charging Nicd;Nimh Battery in Re-Peak Charge Mode; Charge;Discharge & Discharge;Charge Cycle of Nimh;Nicd Battery

· 17
NIMH/NICD BATTERY PROGRAM
Charging NiCd/NiMH battery in re-peak charge mode
Re-peak Charge Mode (NiCd and NiMH batteries only): In re-peak charge mode, the
charger can peak charge the battery once, twice or three times in a row automatically.
This is good for confirming the battery is fully charged, and for checking how well the
battery receives fast charges. A five minute cool-off delay occurs after each re-peak
charge. See the diagram below for using re-peak charge mode. To start charging, press
the Start/Enter button for 3 seconds.
N i M H RE - P EA K
1
N i M H 2. 0 A 9 .5 9 V
R P C 0 00 : 3 3 00 0 1 7
ENTER/START
“Re-peak cycle: 1” shows on the display. Press the Start/Enter
button to make the re-peak cycle number blink and press the
Dec/Inc button to find the desired number of times to re-peak.
Press the Start/Enter button to confirm selection.
Charge/discharge & discharge/charge cycle of NiMH/NiCd battery
DEC
-
Batt type
Stop
INC
+
DEC
Start
Enter
-
INC
+
Battery
type
Elapsed
time
Battery
voltage
Discharged
or charged
capacity
'> 3 seconds '
NiMH CYCLE
CHG＞DCHG 1
NiMH 1.0A 7.42V
C>D 022:45 00890
You can set up sequence on the left and the number of cycles on
the right. Range of the cycle number is 1-5.
Press Batt Type/Stop key to stop program, you can press
Start/Enter key to alter charge current. The sound indicates the end
of program.
Turnigy Mega 1000W