48
8.3.3 Once the desired pressure unit is selected, the standard tire pressure value can be programmed
for each set of wheels. Below is chart of the default tire pressure values per pressure unit:
Pressure units
Default tire pressure value
Note: When using kPa as the unit of air pressure, the monitor will display “Hi” if the air pressure is
over 999kPa. The actual air pressure values will be displayed numerically when the unit of
measure selected is in psi or Bar.
8.3.4 The tire pressure value of the first set of wheels will begin to blink. Press to
increase/decrease pressure value to the standard tire pressure value, then press to set the
pressure value.
8.3.5 The tire pressure value of the next pair of wheels will begin to blink. Repeat step 8.3.4 until each
pair of wheels has been programmed to the standard tire pressure value.
8.3.6 When you have completed the Tire Pressure Units settings for all tires, you will hear a short beep,
indicating that the set tire pressure values have been saved successfully. The receiver will
automatically go to the next TPMS parameter setting: “9.4 Setting Tire Temperature Units” for that
vehicle selection. If no further parameter settings are required, you can hold the for 3 seconds
to switch back to Driving Mode. (Note: If the Tire Pressure Units is NOT programmed within 60
To Next Page
Loading...