53
8.5.6 Press and the “--1” will blink. Press to navigate to tire location number that you would
like to pair. (Note: One or two red dashes “-” and a number (1-10) are used to indicate the tire
location on a Vehicle Selection. Tire location numbers 1-10 on the Tire Sensor ID Pairing
screen
will be the same regardless of the Vehicle Selection.)
8.5.7 Once you are on the selected tire location to pair and while the tire location is blinking, begin
deflating or inflating the corresponding tire. Each tire will have 120 seconds to complete the Tire
Sensor ID Pairing after the blinking starts. (Note: The receiver will emit a long beep and go back to
the Tire Sensor ID Pairing if it DOES NOT receive any signal from tire deflation within 120 seconds.
8.5.8 A short beep will sound and the sensor’s ID number will appear on the receiver indicating that the
sensor signal was received and properly paired to the receiver.
8.5.9 Inflate tire back to standard pressure level.
8.5.10 Press to move to the next tire location you would like to pair.
8.5.11 After completing the Tire Sensor ID Pairing for the vehicle selection, press and the receiver
will automatically go to the next TPMS parameter setting: “8.6 Setting the Tire Position on the
Receiver”
To Next Page
Loading...