58
8.6.3 Press to enter tire position rotation mode, digit “1” will blink by default. Then press
to select the original tire position which needs to be changed and then press again, and the
selected digit at that selected position will turn green and the consecutive digit will begin to blink.
(Note: If no change is made in this mode for 60 seconds, the receiver will beep a long tone to warn
that setting has not been completed successfully and default back to Driving Mode automatically.)
8.6.4 Then press to select digit of the new tire position to which you want to move the
selected original tire position to, and press to confirm, the digit at the new position will also
turn green.
8.6.5 The digits at both exchanged positions will remain displayed in green for 3 seconds to show which
2 tires are exchanged. Then the chosen digits will automatically turn back to red.
8.6.6 Then the screen will show the new positions. If you need to exchange more than one pair of tires,
press to repeat the procedure.
8.6.7 Once you have completed rotating tire positions on the receiver press and hold for three
seconds and the receiver will go to Driving Mode.
To Next Page
Loading...