EN EN
3.3 Add cat litter:
Method 1:
In“Auto”mode, when the adding cat litter is more than 1kg, the "Auto"
will flash. After 30 minutes, the cat litter will be automatically smoothed and
the weight will be automatically calibrated. If you think 30 minutes is
too long to wait, please long press the“Remove odor"button for 2 or more
seconds.The sand will be smoothed immediately and the weight will be
calibrated immediately.
Method 2:
Power off the machine, then powerit on again after adding sand.
MAX Line
The amount of cat litter
should not exceed Max line
MIN Line
The amount of cat litter should
not be lower than Min line
Notice:
①The machine won't stop when it is smoothing sand even cat enters in at this moment.But
don't worry.The machine only swing in some angles, this swing won't hurt cat.(Besides this
situation, the machine have protection function. It will stop immediately once cat walks close
to the entrance during clearing.)
②Please make sure the height of the sand is between MIN line and MAX line after adding.If not,
please adjust it with method 2.
③You can find the sand surface correction option on the App to adjust the position of the
sand.(In grade 0, the sand surface is tilted to the right, and in grade 6, the sand surface is tilted
to the left.)
MAX
MIN
一、Recommended suitable cat litter:
Mineral litter、Bentonite litter
二、Compatibility Cat litter:
1、Tofu litter (diameter not more than 2.5mm, length not more than 15mm)
2、Mixed litter of Tofu litter and Bentonite litter (diameter not more than 2.5mm,
length not more than 15mm).
三、Cat litter that is not recommended:
1、Crystal litter, crystal litter can not clump well, which will bring a serious cleaning
burden to the inner wall of the cat litter basin.
2、Tofu litter with the length of more than 15mm, poor fluidity and filtration, there
will be some stuck inside the filter. This phenomenon can also be alleviated by
adjusting the parameter to 6 by “litter surface calibration” in APP.
3、Low-density cat litter, such as pine wood cat litter and activated carbon cat litter,
it is difficult to rely on its own weight to pass through the filter. Some of them will
be stuck inside the filter. This phenomenon can also be alleviated by adjusting the
parameter to 6 by “litter surface calibration” in APP.
AUTO
FULL
1 4
32
15 16
To Next Page
Loading...
