Individual setting mode
Set the memory switches individually.
Do the settings while confirming the memory switch function and settings on
the printout.
1.
2.
3.
Load paper.
While the paper cover is open, press and hold the FEED button while turning the
power on.
Press the FEED button twice and close the paper cover.
The printer enters the mode for setting memory switches individually.
The printer prints “Memory SW (1)” and the current setting, 0 (off) or 1 (on).
(The current settings for memory switches 7 to 10 are not printed.)
Current memory switch
Current setting
4.
Press the FEED button.
The list of memory switches cycles through in order from “ Memory SW (1)”
“ Memory SW (2)” ... “ Memory SW (10)” “ Save To Memory” “ Memory SW
(1)” each time the FEED button is pressed.
Press the FEED button until the number for the memory switch you want to change is
printed.
-38-
Memory SW (1) 00000000
To Next Page
Loading...
