TVS X - Page 58

TVS X User Manual - Rev 0 - As on 16 July 2024
56
While reassembling the tyres, after
removing from the wheel rim, ensure
that the arrow mark facing the direction
of wheel rotation while fixing the tyre
on the wheel rim.
TYRE PUNCTURE
Your scooter is fitted with a tubeless
tyre on both front and rear wheel.
Incase of any puncture / tyre damage,
it is advised to visit the nearest tyre
manufacturer Dealer or the tyre repair
shops who knows the repairing method
of tubeless tyre.
It is not necessary to remove the tyre
from wheel rim always to attend a
puncture.
Even though, if there is need of tyre
removal, it is strongly recommended to
use a tyre removal / fitment machine.
If at all, tyre levers needs to be used,
the levers should be free from sharp
edges. Care should be taken not to
damage the tyres and rims.
Warning
The tyre ination pressure in cold
condition and the tyre tread condition
are extremely important for the
performance and safety of the rider.
Check the tyres frequently for ination
pressure as well as the wear pattern on
it.
Use of a tyre other than the standard
may cause instability.
Caution
The side walls of the tubeless tyre
which in contact with the wheel rim
are only seals the air inside the wheel
assembly. Hence care should be taken
not to damage the side walls of the
tyres during removal / reassembly.
Note
Tyre pressure is a very important
parameter in the daily operation of the
vehicle. In order to extract the best
possible range and performance.