Twilight Palette Series User Manual

21
13-5. How to set a Offset Function
The Offset Function can be used to multiply/add/subtract a fixed value to the instrument
values. Setting values for "a" and "b" in the equation "y=ax + b" will enable the instrument to
display adjusted values.
y=ax + b
y: adjusted value a: coefficient (multiplication)
x: Brix value b: addition/subtraction number
●Select the scale
１）Press the SCALE Button until the desired scale number is shown.
N Perform while the instrument is powered off. "9. Powering off "Cp.16）"
N When the scale number is locked, release the scale lock.
"13-3.How to release the scale lock"（Cp.20）
●For addition/subtraction (b) [Range: -9.99 to +9.99]
２）Press and hold ZERO Button for approx. 5 seconds.
３）Press ZERO Button to select either "+" or "-."
４）Press START/OFF Button to confirm.
５）Enter the addition/subtraction number.
→ →
The 1st digit: The 2nd digit: The 3nd digit:
ZERO Button to change the number. ZERO Button to change the number. ZERO Button to change the number.
[0,1,2,…8,9,0,1,2…] [0,1,2,…8,9,0,1,2…] [0,1,2,…8,9,0,1,2…]
６）Press START/OFF Button to confirm. The set number will flash three times and proceed to
coefficient (a) settings.
●For coefficient (a) [Range: 0.01 to 10.00]
７）Enter the coefficient (refer to step ５)).
８）Press START/OFF Button to confirm.
→
N To disable the Offset feature, set the Offset value to factory default value (a: 1.00, b:0.00).
N The measurement range is shifted according to the offset settings.
20.3℃
-
2
-
20.3℃
-
3
-
20.3℃
-
4
-
20.3℃
…
-
b
No plus sign will be
displayed.
-b℃
0.00
-b℃
0.00
-b℃
0.00
START/OFF
Button
START/OFF
Button
Confirm
Confirm
℃
End
a
1.00
a℃
1.00
1st 2nd 3rd

Twilight Palette Series Specifications

General

Brand	Twilight
Model	Palette Series
Category	Measuring Instruments
Language	English