http://www.tyan.com
45
3.3.2.1 SATA0 Sub-Menu
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
SATA0
Device: Not Detected
LBA /Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S.M.A.R.T.
32 Bit Data Transfer
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Selects the type of device
connected to the system.
← Select Screen
↑↓ Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
Type
Selects the type of device connected to the system.
Auto / Disabled
LBA/Large Mode
Auto: Enabled LBA Mode if the device supports it and the device is not already
formatted with LBA Mode disabled.
Disabled: Disabled LBA Mode.
Auto / Disabled
Block (Multi-Sector Transfer)
Disabled: The Data transfer from and to the device occurs one sector at a time.
Auto: The Data transfer from and to the device occurs multiple sectors at a time if
the device supports it.
Auto / Disabled
PIO Mode
Select the PIO Mode. Select Auto to enhance hard disk performance by optimizing
the hard disk timing.
Auto / 0~4 (at 1 interval)
DMA Mode
Select DMA Mode.
Auto: Auto detected.
Auto / Disabled
S.M.A.R.T
S.M.A.R.T (Self-Monitoring Analysis and Reporting Technology) is a utility that
monitors your disk status to predict hard disk failure.
Auto / Disabled / Enabled
32-Bit Data Transfer
Enable 32-bit to maximize the IDE hard disk data transfer rate. Enabled / Disabled
To Next Page
Loading...
