Tiger 230 S2507
35
(continued from previous page)
3.7 PnP/PCI Configuration
This section describes the PCI/PnP configuration options available.
(continued on next page)
Wake Up Events (subscreen)
Soft-Off by PWRBTN
Sets time needed to hold down the power button to shutdown
the system. [Default setting is Instant-Off]
VGA
Lets you enter the screen for configuring wake up events.
Sets video activity as power management event. [Default is Off]
LPT & COM
Sets LPT and COM/Serial Port activity as power management
events. [Default is LPT/COM]
HDD & FDD
PCI Master
Sets floppy and HDD activity as power management events.
[Default is ON]
Sets PCI activity as power management events. [Default is Off]
Sets Wake Up on LAN / Ring as power management events.
[Default is Disabled]
Sets Date and Time that system will wake up. [Default is 0]
Wake Up on LAN / RING
Date / Time
Sets RTC Alarm as a power management event. [Default is Dis-
abled]
RTC Alarm Resume
Sets whether IRQ activity should be a power management
event. [Default is ON]
Primary INTR
In this screen, you can assign how power management will
monitor each IRQ.
IRQs Activity Monitoring
(subscreen)
Reset Configuration Data
PNP OS Installed
Sets whether the system is using a Plug-n-Play OS. [Default set-
ting is NO]
Resources Controlled By
(ESCD)
Sets whether the configuration data in the ESCD should be
reset at bootup. [Default setting is Disabled]
Sets how the PnP devices will be controlled. [Default is
Auto(ESCD)]
IRQ Resources
Sets IRQs PnP control statuses.
DMA Resources
Sets DMAs PnP control statuses.
BIOS
To Next Page
