TYM T265 - Page 105

E
MAINTENANCE
E
<Change>
1. Park tractor on level surface.
2. Lower t
he implements and shutoff
engine.
3. Remove the front axle oil cap.
4. Remove the drain plug at the
bottom of the front axle case and
the drain plugs at the front of the
both spindles.
5. Drain the oil completely into
container.
6. Install t
he drain plugs correctly.
7. Fill w
ith new oil to the correct level
in the filler hole.
8. Reinstall the oil cap.
▶ CHECKING AND CHANGING FRONT AXLE OIL
<Inspection>
1. Park tractor on level surface.
2. Lower t
he implements and shutoff
engine.
3. Remove the oil cap.
4. Wipe the dipstick on oil cap.
Dip and screw the oil cap into the
front axle.
5. Unscrew o
il cap and pull out.
6. Check t
he level with the dipstick.
7. If the level is low add oil through
the filler hole.
4. Drain the oil completely into
c
ontainer.
5. Loosen the hose clamp and detach
the hose from the strainer.
6. Remove the bolt and remove the
strainer.
7. Clean the strainer.
8. Reinstall the strainer, bolt and hose.
9
 If transmission fluid gets on your skin, it
can irritate the skin and cause a skin
condition.
Make sure to clean your skin with soap
and water or hand cleaner thoroughly.
CAUTION
 Do not add fluid over the upper limit
level.
 Check the fluid before starting the
engine or at least in 5 minutes after the
engine is stopped.
 When trying to use new fluid from a
different manufacturer or fluid with
different viscosity, drain used fluid
completely before adding new fluid.
IMPORTANT
FILL/LEVEL PLUG
DRAIN PLUGS