MAINTENANCE
E
10
▶ REPLACING FUEL FILTER
This is the primary filter and removes
water and coarse dirt from the fuel.
1. Close the fuel cock.
2. Remove the filter.
3. Wash it or replace the filter element.
4. Bleed the air from the filter.
▶ REPLACING ENGINE OIL FILTER
CARTRIDGE
1. Remove the oil filter using a filter
wrench.
2. Smear lightly the rubber seal on the
new filter with oil to ensure.
3. Turn the filter clockwise until the
seal contacts the base and then
turn it another 2/3 turn to tighten it.
If oil gets on your skin, it can irritate the
skin and cause a skin condition.
Make sure to clean your skin with soap
and water or hand cleaner thoroughly.
Make sure to cool down the engine
sufficiently before draining oil.
Oil is very hot and can cause a burn if
changing oil right after the engine is
stopped.
CAUTION
Do not add front axle oil over the upper
limit level.
Check the front axle oil before starting
the engine or at least in 5 minutes after
the engine is stopped.
When trying to use new oil from a
different manufacturer or oil with
different viscosity, drain used oil
completely before adding new oil.
IMPORTANT
APPLY OIL
When changing the oil always change
the filter.
Always use the same oil, as using
different oils or specifications can cause
damage.
Dispose off the old oil as per local
regulations.
IMPORTANT
FUEL
FILTER
COCK
FUEL
FILTER
ELEMENT
Never use petrol (gasoline) thinner or
similar inflammable material to wash
the primary fuel filter.
After replacing the filter always bleed
the system.
IMPORTANT
To Next Page
Loading...
