MAINTENANCE
E
16
▶ CHECKING ELECTRIC WIRING
1. Loose wiring terminals can cause
contact failure and damaged wiring
can lead to performance
deterioration of electric devices,
short circuit and fire.
Replace or repair aged and
damaged wirings.
2. If wiring sheath is peeled off, wrap
wiring with insulating tape.
3. If fasteners or bands to fix wirings
are damaged, fix wirings with
clamps.
4. Have wiring checked by your
workshop once a year regularly to
avoid fire.
Charge the discharged battery for
approx. 30 minutes after the engine is
started.
▶ BATTERY JUMP START
1. Turn off all electric devices.
2. Connect the positive terminal of the
n
ormal battery to the positive
terminal of the discharged battery
with the jump cable.
3. Connect the negative terminal of
th
e normal battery to the engine
body of the tractor for the
discharged battery with the jump
cable.
4. Firstly, start the engine of the
vehicle with the normal battery.
Then, start the engine of tractor
with the discharged battery.
5. After the engine is started,
disconnect the negative cable first.
Then, disconnect the positive cable.
When charging the battery after
removing it from the tractor, it produces
hydrogen gas, presenting a fire risk.
Charge the battery only in a well-
ventilated area.
The battery produces highly flammable
hydrogen gas which can explode. Keep
flammable items and spark away from
the battery.
The battery electrolyte is sulfuric acid so
can burn your skin and eyes. Be careful
not to spill any.
If the battery electrolyte gets on your
eyes, skin, clothes or object, rinse it with
water thoroughly.
If you swallowed it, drink a lot of water.
Also, get medical attention immediately
if acid contacts your eye or is swallowed.
DANGER
Make sure to connect the positive
terminal first and connect the negative
terminal to the engine body of the
tractor with the discharged battery.
WARNING
To Next Page
Loading...
