EasyManua.ls Logo

TYM T954 - Troubleshooting

TYM T954
189 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
F
TROUBLESHOOTING
2
▶ ENGINE
1. ENGINE TROULESHOOTING
ISSUE CAUSE ACTION
E
N
G
I
N
E
The start motor does not rotate when
the key switch is turned
• Clutch pedal is released
• PTO switch is on「ON」position
• Defective safety switch
• Battery discharged
• Loose terminal
• Faulty key switch
• Defective start motor
• Depress clutch pedal
• Set PTO switch into「OFF」position
• Have it repaired or replaced by workshop
• Charge battery
• Check for looseness and corrosion
Clean, tighten and apply grease
• Have it repaired or replaced by workshop
• Have it repaired or replaced by workshop
The start motor runs, but its speed
cannot be increased
• Weak battery
• Poor ground
• Incorrect viscosity of engine oil
• Charge battery.
• Clean contact and connect ground firmly
• Change engine oil with proper viscosity
The start motor runs, but engine cannot
be started
• Air in fuel system
• Clogged fuel filter
• No fuel supply
• Defective engine
• Defective key stop unit
• Bleed the system
• Clean or replace the filter
• Open the cork and add fuel
• Have it repaired or replaced by workshop
• Have it repaired or replaced by workshop
Engine runs irregularly
• Air in fuel system
• Clogged fuel filter
• Clogged injection nozzle
• Fuel leak from pipe
• Poor fuel injection
• Bleed the system
• Clean or replace the filter
• Have it repaired or replaced by workshop
• Tighten clamp, replace pipe or machine
surface of copper washer before installation
• Have it repaired or replaced by workshop
Engine stops at low speed
• Defective injection pump
• Incorrect engine valve clearance
• Low idle speed
• Faulty nozzle
• Have it repaired or replaced by workshop
• Have it repaired or replaced by workshop
• Adjust speed to the rated speed
• Have it repaired or replaced by workshop