D
OPERATION
2
1. Make sure that there is no obstacle
around the tractor.
2. Seat on driver’s seat and confirm
that parking brake is applied.
3. Check that each shift lever and PTO
switch are in the neutral position.
4. Push down clutch to activate the
safety-starting switch.
5. Insert the key into key switch and
turn it to「ON」position.
Check that warning lights are
working and come off.
6. Turn the key switch to the「START」
position.
When engine is started, release the
switch.
7. Ensure that all warning lamps go off.
▶ HOW TO START ENGINE
When key switch is in「ON」position,
engine is automatically preheated as
necessary.
Glow lamp is on as well.
As soon as preheating operation is
completed, the lamp also goes off.
Engine can be started while the
preheating operation is in progress.
▶ PRINCIPLE OF AUTO
PREHEATING SYSTEM
1. START & STOP OF ENGINE
Never turn the key to「start」position
while engine is running as this can cause
serious damage to starter and engine
flywheel.
Avoiding running the start motor over
10 second.
It consumes lots of current.
If engine cannot be started within 10
second, wait for 30 second and try it
again.
Especially in cold weather, always allow
the tractor to idle for a while to warm up
and build up for a while to warm up and
build up sufficient oil pressure to ensure
normal operating temperature for
longer engine life.
IMPORTANT
Never start engine by connecting start
motor terminal or safety switch directly.
The tractor may move suddenly and
cause an accident.
WARNING
ON
To Next Page
Loading...
