E
MAINTENANCE
4
(1) Inspection
Open the Coolant cap and check if
coolant is filled up to the filler neck. If
not, add more coolant to the radiator.
▶ INSPECTING AND CHANGING
ENGINE COOLANT
(2) Change
1. To drain coolant rapidly, open the
drain cork and remove the radiator
cap simultaneously.
At this time, set the heater cork to
the Open position to drain coolant.
2. Flush the inside of the radiator with
clean water thoroughly.
3. Fit the drain cork and add coolant.
4. Start and idle the engine for approx.
5 minutes and check the coolant
level in the reservoir tank.
Add more coolant as necessary.
If coolant freezes, the engine can be
damaged.
• Clean the radiator thoroughly before
adding antifreeze.
• The mixture ratio of antifreeze is
different by manufacturers and
temperature. Refer to the
manufacturer's manual.
• Mix antifreeze with water sufficiently
before adding it.
• Adding antifreeze
- If evaporated: Add water for the
reduced amount.
- If leaked: Add mixture of antifreeze
and water with the same mixture
ratio.
▶ ANTI-FREEZE
Do not open the cap when the engine is
hot.
Otherwise, hot steam can burn you
seriously.
Wait until the engine is sufficiently
cooled down.
WARNING
If engine coolant gets on your skin, it
can irritate the skin and cause a skin
condition.
Make sure to clean your skin with soap
and water or hand cleaner thoroughly.
WARNING
COOLANT
DRAIN PLUG
3. SERVICING EACH PART
To Next Page
Loading...
