The steps for replacing the sensor battery are as follows.
1. Use power tools to fasten the upper cover of the sensor and the tire valve respectively,
and twirl the sensor housing counterclockwise.
2. Take out the battery from the battery clamp.
3. Install a new lithium battery CR1632 with the positive pole (+) facing upwards.
4. Screw on the sensor housing, and then use a power tool to tighten it clockwise.
Notice：
When installing the sensor housing, be sure to check whether the waterproof rubber ring is
in place. If it is damaged, please replace it with a new one before installing the housing.
Power Tool
The Negative Pole
Lithium Battery CR1632
The Positive Pole
Lithium Battery CR1632
Waterproof
Rubber Ring
To Next Page
Loading...