Tynetec Altec Response - How to Reassign Existing Sensors; How to Switch the Altec Response off; Load Defaults

DocNo.FM0548issueBPage10
13.HOWTOREASSIGNEXISTINGSENSOR
S
Ifyouneedtoreassignanexistingradiosensortoanotherperson/dwellingorsimplyamenditslocation/freetextdetailsthen
followtheprocedurebelow;

FromtheMainMenudisplayselect Radio Devices  andpresstheENTERkey,thedisplayshow;
Radio Devices 

Learn Device

Delete Device
Add/Edit Device
PressENTERagainandthedisplaywillpromptyouto“Trigger the Sensor”.
Learn Device
Trigger Sensor :))

Exit

Activatethedevicewhichyouwanttoamendthedetailsof.
Thedisplaywillshowthedevicetypeandit’s8digitIDnumber.
Personal Pendant
Id: 20044216

Reject

Edit
Ifthisisthedeviceyouactivatedusethekeytoselect Edit  thenpressENTER.
Ifit’sNOTthedeviceyouactivatedpresstheENTERkeytoselect Reject  thentryagain.

Amendthenecessarydetailsasdescribedinsection4ofthismanual.
Toexitthemodepressthekeytoselect Exit  thenpresstheENTERkey.
14.HOWTOSWITCHTHEALTECRESPONSEOF
F
IfpossibletheAltecResponseshouldbeleftpluggedinandswitchedonatalltimes.Thiswillensureitsbatteryisalwaysfully
chargedandalarmcallswillalwaysbereceived.Iftheunitmustbeswitchedofffollowtheprocedurebelow;

SwitchthemainssupplyOFFandunplugpowerlead.
PresstheENTERkeyoncetoilluminatethedisplaythenpressENTERagaintodisplaytheMainMenu.
Pressthekeytoselect Load Defaults  thenpressENTER.
Pressthekeytoselect Power Off 
Load Defaults 
Sensor Defaults
X

Power Off


Apply
Pressthekeytochangethe“X”toa“”
Pressthekeytoselect Apply  thenpressENTER.
Thedisplaywillblank,theunitisnowswitchedoffandwillnotreceiveanyalarmcalls.

Seesection2ofthismanualforhowtoswitchtheAltecResponsebackon.