Tynetec Reach - User Manual

Touch
PersonalPendant



USER&INSTALLATIONGUIDE
www.tynetec.co.uk

Reach
At‐HomeAlarmUnit

Summary

1.1 IMPORTANT INFORMATION

1.3 THE TOUCH PERSONAL PENDANT

1.4 CONNECTING THE REACH AT-HOME ALARM

1.7 SWITCHING THE REACH AT-HOME ALARM ON

1.8 SWITCHING THE REACH AT-HOME ALARM OFF

1.9 MAKING AN EMERGENCY CALL

1.12 USING THE PERSONAL RECIPIENT MODE

1.15 MAINS POWER FAILURE ALERT

1.16 TELEPHONE LINE FAILURE ALERT

1.17 BATTERY FAILURE ALERT

2.1 QUICK START GUIDE

2.2 PROGRAMMING MODE

2.2.1 PROGRAMMING THE UNIT ID NUMBER

Step-by-step instructions for programming the unique unit identification number.

2.2.2 PROGRAMMING THE TELEPHONE NUMBER

2.2.3 PROGRAMMING THE PROTOCOL TYPE

2.3 PROGRAMMING PARAMETERS LIST

2.3.1 LOAD DEFAULTS & PARAMETER CHECK

Procedures for loading default settings and verifying programmed parameters on the Reach unit.

2.3.5 TELEPHONE NUMBERS

2.3.9 RADIO DEVICES

2.4 PROGRAMMING VIA THE CONTROL CENTRE

2.4.1 BY RINGING INTO THE CONTROL CENTRE

2.4.2 BY THE CONTROL CENTRE RINGING THE USER

2.5 RADIO DEVICE LEARN MODE

2.6 RADIO DEVICE TEST MODE

Tynetec Reach Specifications