Tynetec Reach - 2.3.5 TELEPHONE NUMBERS

‐19‐
2.3.1LOADDEFAULT
S
&PARAMETERCHEC
K
LoadDefaults–clearsallprogramming,thepersonalrecipientmessageandallradiodevicesfromthe
Reachmemory.Enter#000;theunitwillannounce“LoadDefaults”thenpress#.

LoadSystemDefaults–clearsallprogrammingfromtheReachmemory.Enter#001;theunitwill
announce“LoadSystemDefaults”thenpress#.

LoadRadioDefaults–clearsallradiodevicesfromtheReachmemory.Enter#002;theunitwill
announce“LoadRadioDefaults”thenpress#.

CheckParameters–confirmstheunitID,telephonenumbers,protocoltype,thependantID(plusany
otherradiodeviceslearnedintotheunit)andthesoftwarerevision.Enter#003andtheunitwill
announcetheabovesettings.
2.3.2
A
UDIOSETTING
S

GSMMode–thismodeshouldonlybeenablediftheReachisbeingconnectedviatheMobilenetwork
usingaGSMunitratherthanaconventionalPSTNlandline.Thispreventsatelephonelinefaultbeing
detectedwhentheGSMunitgoesintolowpowermodeduringamains
failure.
Enter#004;press0toDisableor1toEnablefollowedby#.

SirenVolume–thevolumeofallalarmmessagesanddial‐outtonescanbesetbetween0(off)and5
(highest).Enter#005;theunitwillannounce“SirenVolume”,press0to5followedby#.

AudioVolume–thespeechvolumeto/fromthecontrolcentrecanbesetbetween0(off)and5
(highest).Enter#006;theunitwillannounce“AudioVolume”,press0to5followedby#.

RingVolume–thevolumeoftheinternallygeneratedringtone(thisisonlyusedifthereisno
telephoneconnectedtotheTELsocket)canbesetbetween0(off)and5(highest).Enter#007;theunit
willannounce“RingVolume”,press0to5followedby#.

AudioMode–allowsthecontrolcentresmethodofswitchingthespeechtobeset.Simplexmeansthe
speechdirectionismanuallyswitchedwhereasHalfDuplexisvoiceswitched.Note;alwayscheckwith
thecontrolcentrewhichmethodtheyprefertouse.Enter#008;theunitwillannounce“AudioMode
”,
press0forSimplexor1forHalfDuplexfollowedby#.

MainsFailAlert–allowstheaudible“PleaseCheckYourMainsSupply”messagetobeturnedon/off.
Amainsfailureisreportedtothecontrolcentreafterarandomdelaybetween1and4hours.
Enter#009;theunitwillannounce“MainsDisconnectionAlert”,press0toDisableor1toEnable
followedby#.

AssuranceTone–allowstheaudible“PleaseWait–DiallingforAssistance”messageanddial‐out
tonestobeturnedon/off.Enter#010;theunitwillannounce“AssuranceTone”,press0toDisableor1
toEnablefollowedby#.

TelephoneLineAlert–allowstheaudible“PleaseCheckTelephoneLine”messagetobeturnedon/off.
Enter#011;theunitwillannounce“TelephoneLineDisconnectionAlert”,press0toDisableor1to
Enablefollowedby#.



