11
7. As soon as the engine starts, the indicator box on the
BLACK clamp will blink red and beep to let you know it is ok
to disconnect.
8. Please disconnect the jumper cables from your car within 30
seconds. First remove the RED/POSITIVE (+) clamp and
then the BLACK/NEGATIVE (-) clamp.
9.
Do not allow the metal ends of the jumper cables to touch each
other or the
RED
clamp to touch anything metal on the car.
Now unplug the
BLUE
end of the jumper cable from the
jump starter. This will reset the jumper cable. In 10
seconds the jump starter will power off automatically.
10. Keep the engine running for 20 to 30 minutes, or drive
the car to recharge the battery.
NOTE: If the engine dies shortly after it has been jump started,
or as soon as the jumper cables are disconnected, it probably
means the vehicle charging system is not working (an issue with
the alternator, voltage regulator, wiring problem, or loose/dirty
battery cables). Please seek professional help from a vehicle
mechanic to nd the root cause of the problem.
The Jump Starter may not work correctly for vehicles that require
remote battery jumper locations (e.g.: batteries located in the
boot/trunk or other location). Please consult the owner’s manual
for the vehicle.
JUMP STARTING CONT.:
To Next Page
Loading...
Need help?
General
