25
NEVER attempt to repair or perform maintenance on the unit until the main
electrical power has been disconnected.
1. Will not eject ice (water frozen)
Cause Remedy
■ Control setting too cold ■ Adjust control warmer (counterclockwise)
■ Control defective (1-2 contacts open) ■ Replace control
■ Bin switch defective ■ Replace bin switch
■ Limit switch defective (open) ■ Replace limit switch
■ Ice maker assembly motor stalled ■ Replace motor
■ Broken wire in ice maker circuit ■ Repair or replace wiring
■ Water soaked cabinet insulation ■ Replace foamed cabinet assembly
■ Dirty condenser ■ Clean condenser
2. Will not fill with water
Cause Remedy
■ Water supply valve closed ■ Open water supply valve
■ Water switch defective (open) ■ Replace water switch
■ Solenoid valve defective ■ Replace solenoid valve
■ Fill tube outlet frozen ■ Replace solenoid valve and defrost fill tube
■ Broken wire in water fill circuit ■ Repair or replace wiring
3. Will not stop making ice
Cause Remedy
■ Bin switch defective (closed) ■ Replace bin switch
■ Bin arm binding ■ Lubricate bin arm pivot points or loosen
bin arm lever screw
4. Water will not stop filling
Cause Remedy
■ Water switch defective (closed) ■ Replace water switch
■ Solenoid valve defective ■ Replace solenoid valve
■ Stalled ice maker motor ■ Replace motor
■ Temperature control defective. ■ Replace temperature control
Ice maker is in continuous harvest
cycle (contacts 1-2 closed)
5. Ejector blades will not stop turning
Cause Remedy
■ Control defective (1-2 contacts will ■ Replace control
not open)
■ Hold switch defective ■ Replace hold switch
■ Defective wiring ■ Repair or replace wiring
■ Short in mold heater■ Replace heater
To Next Page
Loading...
Need help?
General