U-Line H-1036 User Manual

PAGE 5 OF 18 0316 IH-1036
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WARNING! Burn Danger – Switch off power,
unplug the dispenser and allow the top heater
to cool down before performing any cleaning,
maintenance or repair.
WEEKLY MAINTENANCE
1. Wash the moistening brush with soap and warm
water. Rinse thoroughly with water.
2. Clean the dispenser using compressed air (NEVER
WATER) to clean off dust and dirt.
MONTHLY MAINTENANCE
1. Lubricate the cutting blades with a drop of oil.
2. Clean the rubber tape advance wheel with water.
DO NOT grease or oil the wheel. Access the wheel
by removing the upper paper guide.
3. Clean the water reservoir with soap and water.
Rinse thoroughly.
4. Clean only the outside of the heater (close to the
brush) with a cloth dipped in decalcifying product.
5. To remove bigger deposits, use a very fine abrasive
cloth or thin blade– Do not scratch or damage the
surface.
6. Replace the heater if deposits cannot be removed
or after 3,500 hours of use.
HEATER CLEANING
WARNING! Burn Danger - Switch off power,
unplug the dispenser and allow the top heater
to cool down before attempting to clean
the heater.
CAUTION! NEVER use water or liquid to clean
the top heater.
MAINTENANCE AND CARE

U-Line H-1036 Specifications

General

Brand	U-Line
Model	H-1036
Category	Dispenser
Language	English

Summary

General Safety and Usage

Important Initial Warnings

Read manual thoroughly, familiarize with controls, keep for future reference, check for damage upon receipt.

Technical Data and Specifications

Machine and Tape Specifications

Details on dimensions, weight, power, dispensing speed, length limits, tape types, and paper features.

General Information and Setup

Safety and Operational Guidelines

Only trained personnel, use gummed tape only, verify voltage, keep machine clean and dry.

Install Water Reservoir and Bottle

Steps to wash, insert, and attach the water reservoir and fill the water bottle.

Install Brackets and Top Heater

Mounting bottle brackets and installing the top heater assembly onto the dispenser.

Tape Dispenser Setup and Operation

Guide and Tape Loading

Installing the upper plate guide and loading the tape roll correctly.

Dispensing and Programming Tape Lengths

Using preset, custom, and programmed lengths, including intermediate settings.

Top Heater Usage and Storage

Instructions for using the top heater and proper storage when the dispenser is not in use.

Maintenance and Care

Routine Maintenance Schedule

Weekly tasks include washing the brush and cleaning with compressed air.

Monthly Maintenance and Cleaning

Lubricate blades, clean components, and specific instructions for heater cleaning.

Reference Information

Component Identification

Diagram and key identifying all parts of the electronic kraft tape dispenser.