U-Line H-3642 - Page 2

PAGE 2 OF 9 0621 IH-3642
ASSEMBLY CONTINUED
2. Align armrest with holes on bottom of seat cushion.
Use one 1/4 x 1" screw (8) and two 1/4 x 1½" screws (10)
to attach. Repeat on opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism with holes on bottom of seat
cushion with tension knob facing the front of seat.
Use four 1/4 x 1" screws (8) to attach. (See Figure 3)
4. Align back support mounting plate with holes on
bottom of seat cushion. Use four 1/4 x 1¼" screws (9)
to attach. (See Figure 4)
Figure 2
Figure 3
Figure 4
10
8
8
9
Front of
seat