PAGE 5 OF 8 0422 IH-9884
SETTINGS CONTINUED
MAINTENANCE
MODE MENU
NOTE: This sub-menu activates modes so they
will be available for use with the MODE button.
Weigh mode is always active.
• Parts Count [COUNT] (on, off) – Set to "ON" for the
mode to be active.
• Check Weigh [Check] (on, off) – Set to "ON" for the
mode to be active.
UNITS MENU
NOTE: This sub-menu activates units so they will
be accessible with the UNITS button. The units
in the menu must be turned on to be active.
NOTE: Available units and modes vary by
model and local regulations.
SECURITY SWITCH
• Menu Lock switch may be used to limit changes to
the user menu. (See Figure 4)
• The switch may set some scale settings as required
by the approval agency.
• The switch may be secured using paper seals, wire
seals or plastic ties.
Unlocked
Locked
Figure 4
WARNING! Electric shock hazard. Disconnect
the equipment from the power supply before
cleaning.
ATTENTION! Do not use solvents, harsh
chemicals, ammonia or abrasive cleaning
agents.
• Clean the main housing with a damp cloth and mild
detergent, if necessary.
To Next Page
Loading...
