28
User’s Manual
CARE AND CLEANING
Periodic cleaning and proper maintenance will ensure efficiency, top
performance, and long life. We suggest the following:
• The interior may be cleaned with a mild detergent and warm water.
•Avoid the use of solvent cleaning agents or abrasives on the interior.
These cleansers may transmit taste to the ice cubes and food, or
damage or discolor the interior.
• The exterior may be cleaned with a mild detergent and warm water.
• The front grille should be kept
free of dust and lint to permit free
air flow to the condenser (see
Figure 41). The condenser coil,
located behind the front grille,
should be cleaned three to four
times each year. Use a brush or
vacuum cleaner to remove dirt,
lint and other accumulations
from the condenser coil.
UL005A
Figure 41
The condenser fins are SHARP. DO NOT run hands over
condenser fins.
The solenoid valve inlet screen must be cleaned at least once each year
as follows:
1. Shut off the water at the water supply valve.
2. Remove the entire hose con-
nector from the solenoid valve.
3. Use a tooth brush to clean
sediment from the inlet screen
(see Figure 42). DO NOT
remove the screen.
4. Attach the hose connector to
the solenoid valve. Tighten con-
nector securely with a pliers.
Open the water supply valve
and check for leakage at the
hose connector.
UL123
Figure 42
Users Manual 41923 9/2/03 3:44 PM Page 28
To Next Page
Loading...
Need help?
General
