26 27
Kickstand
The 2×2’s kickstand has an auto-retract design so
the bike cannot be ridden with the stand down,
reducing the risk of the stand catching.
It’s important that you keep body parts clear of the
stand when removing weight from the stand.
To engage the stand:
a. Use your foot to rotate the stand down to the
ground until it reaches the down stop.
b. While maintaining the pressure on the stand
with your foot, lean the 2×2 over until the
weight of the bike is on the stand.
c. Ensure the weight of the bike is resting on the
stand and that the stand is secure.
Retracting the stand:
a. Simply remove the weight of the bike o the
stand and keep body parts clear of the stand
− the kickstand spring will cause the stand to
retract with force.
b. Or, use your foot to help guide the stand back
to its stowed position.
Adjustable Suspension
Front:
The front forks have adjustable rebound
dampening controls that control the rate the
suspension re-extends after an impact.
This feature can be adjusted on the top right-hand
side of the fork crown. Twist the dial clockwise to
slow the rebound; counter-clockwise to speed it up.
You now have all the information you need to get started! We recommend making yourself familiar with
the information in the following sections before you take the bike out for a spin.
We hope you enjoy the 2018 Ubco 2×2, and remember, always ride safe.
Rear:
The 2×2’s rear suspension comes set to an
average user setting but can be adjusted.
Wind the disk at the base of the spring
clockwise to lessen the spring force and make
the suspension softer. Twist counter-clockwise
to increase the spring force and make the
suspension stier.
The rear forks also have adjustable rebound
dampening control. It can be adjusted using the
red dial at the top of the spring. Twist the dial
counter-clockwise to slow the rebound; clockwise
speeds it up (this is opposite to the front fork).
The rear suspension and rebound dampening
control should be set equally on both sides.
To Next Page
Loading...
Need help?
General
