EasyManuals Logo

UBCO 2x2 2018 User Manual

UBCO 2x2 2018
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
30 31
Charging Your Battery
How to charge the battery:
a. Turn o the bike and remove the key.
b. Plug the provided charger into any standard
wall socket and switch on at the wall.
c. Plug the charger into the battery charge port on
the console and twist to lock.
d. The LED indicator lights on the charger will
signal:
A GREEN: Battery is full or disconnected
A RED – Solid: Charging
A RED – Flashing: Charge error
If a charge error occurs, disconnect the charger
from battery and wall socket. Reconnect. If flashing
persists, contact your service provider.
Charger Settings
The charger has two settings: Max and Normal.
The recommended setting is Normal.
Normal Setting: Charges the battery to 90%
capacity. This setting is ideal of those not using
a full discharge and will extend battery life.
Charge port
Plug in charger
here.
Bike socket
Connect the
battery to the
bike here.
Max Setting: Charges the battery to 100%
capacity. This setting is useful for high intensity
environments and those that require maximum
daily range.
When charging:
A Keep away from any sparks or flames.
A Install a smoke alarm near your charging area.
A Do not charge if cables, charger, or battery
are damaged.
A Use charger in dry, indoor conditions only
and with adequate ventilation.
Checking Battery Charge
To check the capacity of your battery, ensure the
battery is plugged in to the bike and turn the key
to ACC or RUN. The battery meter display on the
left hand side of the LCD display will indicate the
remaining charge and will flash when the charge
gets low.
The yellow ‘Charge Required’ light at the top of
the display will also illuminate when the remaining
charge is low.
Never store the battery in an
uncharged state. Doing so can void
the warranty. Always top up after use.
It is important that the plug, socket,
and charge ports stay clean and in
good condition to operate properly. If
the battery is removed, ensure that the
battery plug is reinstalled correctly.
A battery socket is located on the right-hand side
(when sitting on the bike) of the battery case.
Charge ports are located on the front of the battery
and on the right side of the console.
TOOL TIP: Attach the
battery strap between the
two handles for an easy
carrying strap.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UBCO 2x2 2018 and is the answer not in the manual?

UBCO 2x2 2018 Specifications

General IconGeneral
CategoryScooter
MotorBrushless DC
BrakesHydraulic disc brakes
SuspensionFront and rear suspension
Charging Time6-8 hours
Motor Power2000 W
Battery48V Lithium-Ion
Range120 km
Top Speed50 km/h
Load Capacity150 kg
TiresKnobby tires

Related product manuals