4544
06
MAINTENANCE
& CARE
Do:
• Clean your 2×2 after each day of use, especially
when exposed to dirty terrain or salt water. If
you are using the 2×2 in a clean environment,
this may not be necessary.
• Before cleaning, turn the 2×2 o and remove
the key. Ensure all power outlets, including
the battery, have their rubber seals securely in
place. The battery should be plugged into the
bike while cleaning.
• Clean the bike with a low pressure hose and
soft automotive cleaning brush or sponge.
Do Not:
• Do not water blast or use a high pressure hose
on the bike.
• Do not submerge electrical parts – they are
protected from the rain and splashes, but
should not be left in water.
• Do not use cleaning products that are not
specifically designed for cars or motorcycles.
They may contain ingredients that could scratch
the finish or harm components of the 2×2.
Cleaning
It's important to keep your 2x2 in a good working order so it's ready to go when you are. To ensure it's always
in the best condition possible, you should clean your 2x2 after every ride.
Incorrect cleaning methods can void your warranty, so take care and make sure you follow the below points.
To Next Page
Loading...
Need help?
General
