Ubee Interactive Using the Pass Through Option
Ubee DDW36C Advanced Wireless Gateway MSO Operations Guide • October 2015 60
4. Click Apply. The port trigger rule is created and displayed in the table. Field
descriptions are listed below the screen example.
The following example shows the Port Triggering option set up for a dual Xbox
configuration.
6.7 Using the Pass Through Option
Use the Pass Through option to configure a pass through table. Devices in the pass
through table are treated as bridge devices, storing and forwarding data between LAN
interconnections.
Label Description
Trigger Start Port Defines a port number or the starting port number in a range
of port numbers.
Trigger End Port Defines a port number or the ending port number in a range of
port numbers.
Target Start Port Defines a port number or the starting port number in a range
of port numbers.
Target End Port Defines a port number or the ending port number in a range of
port numbers.
Protocol Defines the protocol type for this rule, UDP, TCP, or Both.
Description Names the triggering rule.
Enabled Enables (on) or disables (off) the triggering rule.
Remove All Deletes all port triggering rules.
Edit Allows you to edit a port triggering rule.
Remove Deleted a port triggering rule.