Ubee Interactive Using the Access Control Option
Ubee DDW36C Advanced Wireless Gateway MSO Operations Guide • October 2015 83
Label Description
2.4GHZ / 5GHz (top left side) On the top left side of the screen, you can select either the
2.4GHz or 5GHz radio band to configure.
Wireless Interface Defines the network name (SSID) and MAC address for which
you are setting access control parameters. The screen shot
above shows the SSID for the 2.4GHz radio.
MAC Restrict Mode Controls wireless access to your network by MAC address.
Disabled turns off MAC restrictions and allows any
wireless client to connect to this device. However, if you
use other security mechanisms for access to the wireless
network, clients must still adhere to those restrictions.
Allow creates a list of wireless clients that can connect to
the wireless network. Enter the MAC addresses of these
clients in the MAC Addresses fields. MAC addresses not
on the list, are not allowed access to your wireless
network.
Deny creates a list of wireless clients that you do not
want to have access to your wireless network. Enter the
MAC addresses of these clients in the MAC Addresses
fields.
To Next Page
Loading...
Need help?
General
